Changes in This Release:

• Support for changing the language of the web UI
• Added "All" and "None" links to the "Add Devices to Button" dialog. This allows the user to add all currently unassigned devices, or to clear any newly selected devices with one click.
• Added translations for Spanish, French and German.
• Fixed issues in which many browser caching caused false failures in the web interface has been fixed
• Fixed Adding Device while connected via Zeroconf no longer experiences issue with unexpected exit of mode
• Fixed issue with displaying programming and occupancy info in Internet Explorer
• Fixed issue in which changing button programming type failed if there was only one device in the system and "clear programming" was selected
• Fixed issue in which web UI displayed that a device had been factory reset long after this even has occurred
• Fixed issue in which querying the LED state of a unprogrammed button over integration did not produce a response
• Fixed several issues in entering and exiting add devices mode
• Fixed issue in which rapid-tapping of raise/lower caused the NXB-CCG to think it had moved more than it actually had (reported levels were incorrect)
• Fixed lower to low-end LED tracking
• Fixed issue in which limit set mode timeout was not being shown in the web UI
• Fixed issue in which stale programming was left on devices when a wall keypad was removed and re-added
• Fixed issue with retry button behavior in UI after programming failure
• Fixed issues with extracting XML in systems with raise/lower buttons
• Added test programming button to occupancy sensor programming (missing in previous releases)
• Fixed confusing UI message when activating devices during identification
• Fixed issue in which renaming a button in the Program page cause incorrect updating of the currently selected button name being displayed
• Added password confirmation for integration logins
• Fixed firmware update process to show proper success/failure feedback upon completion
• LEDs on keypad buttons are re-synced after making button configuration changes
• Failed button configuration changes are now synchronized the next time the keypad is heard from.
• Fixed an issue that could cause programming operations to be locked out after changing a button's configuration
• Fixed an issue that would cause a crash if no devices responded when changing programming models and clearing programming.

Known Issues:

• It is recommended that steps be taken to ensure power to the device does not fail during firmware updating. Power failure during firmware update can result in corruption to the database.
• Issuing integration commands to control dimmers too quickly (> 5-10 commands per second) can cause commands to be dropped and can result in long delays in the Clear Connect system.
• Making more than 50 simultaneous connections to the CCT can cause the NXB-CCG to become unresponsive. A power cycle of the device will fix the issue.
• Downgrading the NXB-CCG firmware may delete all programming.
• Using Zeroconf resolved host names to access the web pages is slow in some browsers. If this is experienced, log out and re-connect to the device using its IP address.
• CCT requires reboot when changing physical network connection manually (ie. connecting cable, removing connection to router and connecting to other router or PC, etc.)
• An issue was found in which a power cycle of the NXB-CCG during or just after a firmware update could cause the unit to not be downgradeable to a previous release.
• When using Link Local addressing, the DNS servers and domain name shown in the web UI may be inaccurate.
• Login via standards compliant telnet client may fail first login. Subsequent attempts to log in will work properly.
• In very rare instances, the web server may stop responding, displaying "The page you are looking for is temporarily unavailable. Please try again later." If this continues for more than 5 minutes, cycle power to the device to clear the error.

This firmware is programmed into an E-PROM chip and not available as a download. Please order the free replacement chip using part number: PC606-A.

• Improved ProLink interface error detection and message handling
• Added phase/zero-crossing detection and correction features at startup and reset
• Reduces AxLink controller lock-ups and Radia devices from dropping off line

Known Issues: This firmware disables most of the return responses from ProLink programming strings. AxLink responses and feedback will work as normal.